Campi LIE2010: OBD Virtual Read on AutoTuner Tool and AutoTuner One
Dear Users,
We are pleased to announce official support for the Campi LIE2010 engine control unit via OBD Virtual Read on your AutoTuner Tool and AutoTuner One. This software release enables direct diagnostic port calibration for the iconic 6.5i V12 engine powering Lamborghini flagship models produced from 2011 to 2022, including the Aventador, Veneno, Centenario, Sian FKP 37, and Countach.
💡 ECU Spotlight: What You Might Not Know
What does it take to keep a 6.5 liter naturally aspirated V12 revving beyond 8,500 rpm under control, twelve cylinders at a time? 🤔
The answer is the Campi LIE2010, introduced in 2011 with the Lamborghini L539 V12. At its core sits the Freescale MPC5567, a 32 bit Power Architecture microcontroller running at 132 MHz with 2 MB of internal flash. Its secret weapon is the eTPU (enhanced Time Processing Unit), a dedicated coprocessor with 32 timing channels that schedules every injection and ignition event on its own, leaving the main core free for torque and calibration calculations.
Beyond pure fuel and spark, the LIE2010 manages variable valve timing on intake and exhaust, the cylinder deactivation system that shuts down a full bank of six cylinders at low load, and a Stop & Start function fed by supercapacitors rather than a conventional battery, a technology Lamborghini later carried over to its first hybrids. With Specific Datalogs also available on this protocol, you can monitor key V12 parameters straight through the diagnostic port to fine tune every calibration.
⚙️ Key Features:
- Devices: AT Tool & AT One
- Type: Engine Control Unit (ECU)
- Mode: OBD Virtual Read
- Readout: ASW + Calibration
- MCU: MPC5567
- Write time: 6min45sec
- Checksums correction
- Specific Datalogs
See the full compatibility list below.
Update your AutoTuner software today and elevate your workshop capabilities!
The AT Team





